51 14 010 Removing And Installing/Replacing Rear BMW Badge

Special Tools Required

00 9 322

IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

Heat BMW badge (1) with hot air blower and lever out with special tool 00 9 322 .

Fig 1: Heating BMW Badge Using Special Tool 00 9 322

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pull liner* off adhesive tape (1).

Position badge over guides (2 and 3) and press down firmly.

*Liner is the protective film on a new badge.

Fig 2: Identifying Guides & Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.