51 24 050 Removing and installing/replacing lock (lock cylinder) for rear lid

Necessary preliminary tasks:

Disconnect plug connection (1) on microswitch.

Detach Bowden cable (2) from holders.

Move lock actuator (3) in direction of arrow up to end stop.

Fig 1: Moving Lock Actuator In Direction Of Arrow Up To End Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and turn complete lock (2) in direction of arrow.

Fig 2: Releasing Screws And Turning Complete Lock In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Turn lock (1) to right until guide (2) is located in metal cutout (3).

Remove lock in direction of arrow.

Fig 3: Removing Lock In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Perform function check with trunk lid open.

Replacement only:

Pull off rubber grommet (1).

Fig 4: Pulling Off Rubber Grommet

Courtesy of BMW OF NORTH AMERICA, INC.