12 14 600 Removing/replacing knock sensors (N52, N52K, N51)

IMPORTANT: Aluminium-magnesium materials.
No steel screws/bolts may be used due to the threat of electrochemical corrosion.
A magnesium crankcase requires aluminium screws/bolts exclusively.
Aluminium screws/bolts must be replaced each time they are released.
The end faces of aluminium screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage).

Necessary preliminary tasks:

Read out fault memory of DME control unit
Switch off ignition
Disconnect battery negative lead 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD
Remove intake air manifold

Unlock plug (1) and remove.

Fig 1: Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws on both knock sensors (1) and remove knock sensors (1).

Installation:

Replace aluminium screws.

Tightening torque: 12 14 1AZ, see 12 14 ELECTRONIC SHIFT UNITS OR CONTROL UNITS .

Fig 2: Knock Sensors

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean support face of knock sensors on engine block.

Fig 3: Support Face Of Knock Sensors

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Now clear the fault memory.