51 24 130 Removing and installing/replacing striker for rear lid lock (Touring)

Necessary preliminary tasks:

Remove trim (1) on rear lid.

Fig 1: Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on striker (2).

Fig 2: Screw And Striker

Courtesy of BMW OF NORTH AMERICA, INC.

Screw threaded pin (1) into threaded plate of striker (2).

Unscrew bolt (3).

Remove striker (2) from rear lid panel (4).

Fig 3: Threaded Pin, Striker And Rear Lid Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Threaded pin (1) remains in threaded plate (2) until striker is fitted.

IMPORTANT: Do not close trunk lid, risk of damage.

Installation:

Adjust striker to lower section of trunk lid lock.

Fig 4: Threaded Pin, Striker And Rear Lid Panel

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Striker and rear lid lock must not be greased.