84 11 519 Removing and installing or replacing eject box

Special tools required:

Pull off gaiter (1) towards top.

Disconnect plug connection (2).

Unclip plug connection for antenna lead from mounting and disconnect.

Fig 1: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Snap out eject box (1) with special tool 00 9 340 on inner side of trim (2).

Pull eject box (1) on inner side upwards slightly.

Fig 2: Pull Eject Box On Inner Side Upward

Courtesy of BMW OF NORTH AMERICA, INC.

Snap out eject box (1) with special tool 00 9 340 on outer side of trim (2).

Lift out eject box (1) and feed out wiring harness.

Installation:

Make sure wiring harness is correctly laid.

Eject box (1) must snap audibly into trim (2).

Fig 3: Eject Box (1) Must Snap Audibly Into Trim (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on trim (2) must not be damaged or missing.

Fig 4: Identifying Catches On Trim

Courtesy of BMW OF NORTH AMERICA, INC.