51 47 490 Removing And Installing / Replacing Front Underbody Protection

Except BMW ALPINA B7:

Release expansion rivet (1).

Release screws (2) and then catches in area (A).

Remove underbody protection (3) towards rear.

Installation:

Ensure correct seating.

Centre underbody protection (3) and secure.

Fig 1: Identifying Expansion Rivet And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Version with bad weather package:

Release screws (1).

Release screws (2) and remove underbody protection (3) downwards

Installation:

Replace screws (2).

Fig 2: Identifying Underbody Protection Screws

Courtesy of BMW OF NORTH AMERICA, INC.

BMW ALPINA B7:

Release screws (1) and remove holder (2).

Release retaining elements (3) and remove underbody protection (4).

Fig 3: Identifying Screws And Remove Holder

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing - except BMW ALPINA B7:

Release screws (1).

Release catches (2) and remove lip (3).

Fig 4: Identifying Catches And Lip

Courtesy of BMW OF NORTH AMERICA, INC.