51 71 Seals and Loose Body Parts

TIGHTENING TORQUE SPECIFICATION - SEALS AND LOOSE BODY PARTS

	Type	Thread	Tightening specification	Measure
1AZ Front spoiler to bumper	E36/M3	-	-	3 Nm
2AZ Rear spoiler	E34/Touring, E36/Z3 Coupe/M Coupe	M6	-	6 Nm
-	E36/M3	M6	-	7 Nm
-	E53	-	-	3 Nm
-	E83	M6	-	10 Nm
-	E61	-	-	8 Nm
3AZ Reinforcement plate to front axle support/engine carrier	E46 / without AWD, E85, E86	-	Replace screws	-
-	-	-	Jointing torque	59 Nm
-	-	-	Torque angle	90°
4AZ Tension strut in engine compartment	E85, E86	-	Nut	41 Nm
-	-	-	Replace screw	56 Nm
-	-	-	Torque angle	105 ±15°
-	E83	M8	-	19 Nm
5AZ Reinforcing plate / tension strut to rear axle	E46 / Convertible, E85, E86	M10	Replace screws	-
-	-	-	Jointing torque	59 Nm
-	-	-	Torque angle	90°
6AZ Stiffening plate to body	E85, E86	M8	-	21 Nm
7AZ Tension strut to rear axle	E46 / Convertible	M8	-	24 Nm
-	E85, E86	-	Replace nut	24 Nm
8AZ Cross-member, A-pillar, to mounting	E52	M8	-	19 Nm
9AZ Cross-member, A-pillar, middle	E52	M8	-	10 Nm
10AZ Strut to cardan tunnel	E52	M8	-	19 Nm
11AZ Cross-member, A-pillar, bottom, to mounting	E52	M6	-	11 Nm
12AZ Support tube to support, steering column upper section	E65, E66, E67	M8	-	21 Nm
13AZ Support tube to body	E85/E86	M8	-	20 Nm
14AZ Heater to support tube	E85, E86	-	-	4 Nm
15AZ Support tube to body	E60, E61, E63, E64, E83	M8	-	21 Nm
16AZ Take-up, cover, sill to body	E83	M8	-	5 Nm
17AZ Cover, partition, to body, front	E61	-	-	2.5 Nm
18AZ Retaining strip, sill trim, to side panel	E61	-	-	5 Nm
19AZ Multifunction pan to body	E60 / M5	-	-	3 Nm
-	E86	-	-	12 Nm
20AZ Underride protection to retaining bar	E60, E61	M8	Replace screws	8 Nm
-	E60, E61	M8	Replace screws	8 Nm
21AZ Retaining bar for underride protection to frame side member	-	-	-	-
22AZ Protective mat/protective cover to body	E60 / Security	M6	Screw	10 Nm