25 11 071 Replacing knob for shift lever

NOTE: Do not twist knob during removal as this would cause the turning lock in the knob to shear off.

Tug firmly to remove knob.

Installation:

Fit knob on selector lever, align and press on until it snaps noticeably into place.

NOTE: Illustration shows E46.

Fig 1: Removing Knob

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Push rubber gaiter (1) down until groove (2) is fully exposed.

Fig 2: Pushing Rubber Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.