66 20 518 Removing and installing/replacing a front ultrasonic sensor (center)
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work
- Remove FRONT BUMPER PANEL
Disconnect plug connection (1) and unclamp ultrasonic sensor from retaining tabs (2).
Installation note:
Before installation of ultrasonic sensor on wiring harness, clean plug connection!
Retaining tabs (2) must not be damaged!
Make sure ultrasonic sensor is securely seated.
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).