51 14 110 Removing and installing/replacing rear model designation

WARNING: This page is about a different car, the 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The "INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING " serve as the basis for these repair instructions and must be followed without fail.

Mark dimensions (A and B) on rear lid.

A = 20 mm; B = 146 mm

Stick on model designation using markings.

NOTE: Measurement "C" is for information purposes only, as it is determined by carrier film.

C= 9.2 mm

Fig 1: Identifying Model Designation Dimensions

Courtesy of BMW OF NORTH AMERICA, INC.