51 43 251 Removing and installing/replacing trim for rear left or right roof pillar (rear)

WARNING: FOLLOW safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Lever out airbag emblem (1) and release screw underneath.

Installation:

Tightening torque 51 43 1AZ .

Unclip clip (3) and clips (4) of trim (2) and pull out trim (2) inwards and upwards.

Fig 1: Identifying Airbag Emblem, Clips And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 2: Identifying Retainer And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of trim (4) must not be damaged or missing:

Fig 3: Identifying Trim, Guide And Clips

Courtesy of BMW OF NORTH AMERICA, INC.