Removal Of Side Wall Holder (Variant 2)

Release welded connection in area (1) and remove holder (2).

Fig 1: Removing Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part: 

Fit in new part.

In area of adhesive surface (1), drill a 4.2 mm dia. bore hole (2) for blind rivet N3.

Remove new part and deburr holes.

Fig 2: Identifying Location For Bore Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Installation of side wall holder: 

Clean all bonding surfaces with cleaning agent R1.

Apply adhesive to bonding surface.

Install new part and rivet with blind rivet.