63 21 180 Removing and installing/replacing left or right rear light

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect plug connection (1).

Release nuts (2) and remove rear light (3) towards outside.

Fig 1: Identifying Plug Connection, Rear Light And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe tightening sequence for 4 retaining nuts.

Tightening torque 63 21 1AZ .

NOTE: Gap dimension to body side panel is established by means of retaining nut (4).

Avoid twisting rear light when screwing down.

Fig 2: Identifying Retaining Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure rear light seal (1) is correctly seated, replace if necessary.

Buffer stop (3) of rear light (2) must be fitted.

Fig 3: Identifying Rear Light Seal And Buffer Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: