61 31 238 Removing and installing/replacing Lane Departure Warning motor electrics (standard steering wheel)

Necessary preliminary tasks:

Release screws (1) and remove retaining plate (2).

Tightening torque 32 33 2AZ .

Fig 1: Identifying Retaining Plate And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release screw (2).

Release screws (3) and remove motor electrics (4) complete with electrical wires.

Fig 2: Identifying Motor Electrics, Plug Connection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace screws (2 and 3).

Ensure correct cable routing.