51 13 115 Removing and installing/replacing cowl panel cover
Necessary preliminary tasks:
- Remove both WINDSHIELD WIPER ARMS
- Remove LOWER MICROFILTER HOUSING SECTION on left and right
Release plastic nut on left/right.
Turn quick-release fasteners (2) approx. 90° counterclockwise.
NOTE:
The fastener is closed if the arrow tips point to each other.
Release screw (1).
Remove cowl panel cover towards top.
Installation:
Tighten down screw (1) to tightening torque 51 13 5AZ .
Check cover (3) for correct seating.
Tighten quick-release fasteners (2) from the middle.