Necessary preliminary tasks
- Remove IGNITION COILS
- Release WIRING HARNESS SECTION FOR IGNITION COIL in cylinder head cover area
- Remove TENSION STRUT
Unlock and detach vent hose (1).
If necessary, pull off metal bracket (2) in direction of arrow.
Release screws (3) on electric servomotor.
Tightening torque 11 37 3AZ .
NOTE:
A further screw, which cannot be seen in the picture, must be released under the electric servomotor (4).
Release screw on electric servomotor.
Tightening torque 11 37 3AZ .
Remove servomotor (4) in direction of arrow.
If necessary, release nuts (5).
Tightening torque 11 72 1AZ .
If necessary, remove secondary air valve (6).
IMPORTANT:
Observe different screw lengths.
Installation location of screws (1 and 2) is specified by the different bushing shapes.
Installation location of screws (1 and 2) is specified by the different bushing shapes.
Release screws in area (1).
Tightening torque 11 12 5AZ .
Installation: