51 37 000 Removing and installing complete rear left or right power window unit

Necessary preliminary tasks:

Slacken screws (1 and 2) (do not release).

Remove clamp (3) in direction of arrow.

Fig 1: Removing Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guide (1) is correctly seated when fitting clamp (2).

Fig 2: Identifying Guide And Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw on power window unit (2) through bore (1).

Disconnect plug connection (3) from drive (4).

Feed power window unit (2) in direction of arrow out of inner door panel.

Fig 3: Removing Power Window Unit From Inner Door Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1) and detach flat motor (2).

Fig 4: Identifying Flat Motor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: The power window unit must be reinitialized after it has been installed. See 67 62... NOTES ON INITIALIZING POWER WINDOW .