51 47 312 Replacing footrest for front passenger compartment

Necessary preliminary tasks:

Remove trim panel for pedal assembly

NOTE: Footrest (1) is glued to carpet along line (2).
Adhesive bead must remain on carpet (risk of damage).
Heat footrest (1) with hot air blower and thereby release adhesive bead from footrest (1).
If necessary, place footrest (1) under tension with assembly wedge and pull off in inward direction while applying heat.

Fig 1: Footrest (1) Is Glued To Carpet Along Line (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Heat footrest (1) with hot air blower and apply adhesive bead along line (1) with hot-melt adhesive gun.

Place footrest (1) on carpet and stick on.

Fig 2: Identifying Footrest

Courtesy of BMW OF NORTH AMERICA, INC.