12 31 Alternator with Drive and Mounting Parts
TIGHTENING TORQUE SPECIFICATIONS - ALTERNATOR WITH DRIVE AND MOUNTING PARTS
| Type | Thread | Measure | |
|---|---|---|---|
| 1AZ Wires to alternator | |||
| Terminal D+ | M10/M20 | 5 Nm | |
| All / others | M6 | 7 Nm | |
| Terminal B+ | S38 / B38 | 8 Nm | |
| All / others | M8 | 13 Nm | |
| 2AZ Pulley | All | 45 Nm | |
| 3AZ Pulley (ribbed drive belt) | Alternator with cooling jacket | 80 Nm | |
| all others | 70 Nm | ||
| N42, N46 Valeo | 75 Nm | ||
| N42, N46 Bosch | 65 Nm | ||
| 4AZ Rear holder | All | 3.5 Nm | |
| 5AZ Fillister head screw for wire holder | All | 3.5 Nm | |
| 6AZ Alternator on bearing block | M40/M42 / M43 / M44 | 43 Nm | |
| 7 AZ Alternator to crankcase | N42, N46, N62 | M8 | 21 Nm |
| 8AZ Belt pulley (ribbed V-belt) with freewheel (Ina) fitted to Bosch and Valeo alternators | N42, N43 | 80 Nm |
TIGHTENING TORQUE SPECIFICATIONS - ALTERNATOR WITH DRIVE AND MOUNTING PARTS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Wires to alternator | N52, N52K, N51, N53 | M8 | 19 Nm | |
| 2AZ Alternator to crankcase | N52, N52K, N51, N53 | M8x82 | Replace screws | |
| Jointing torque | 10 Nm | |||
| Torque angle | 180° | |||
| 3AZ Belt pulley (ribbed V-belt) with freewheel (Ina) fitted to Bosch and Valeo alternators | N52 | 80 Nm |