72 12 050 Removing and installing or replacing side airbag, front left or right seat (convertible)

WARNING: Observe SAFETY REGULATIONS when handling airbag modules.
Incorrect handling may result in activation of the crash-active head restraint and thereby cause injury.

Disconnect BATTERY EARTH LEAD
Remove REAR PANEL

Unhook backrest cover (1) in marked area.

Fig 1: Identifying Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock PLUG CONNECTION (1) and disconnect.

Release screw (2).

Installation:

Replace screw.

Tightening torque: 40 +/- 5 Nm.

Fig 2: Identifying Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock airbag module (1) in downward direction and remove sideways from backrest frame.

Fig 3: Removing Airbag Module

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage welt from airbag module (1).

Fig 4: Disengaging Welt From Airbag Module

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Bracing (1) must be fitted under airbag module.

Close bracing (1) of backrest cover before fitting airbag.

Feed airbag module (2) into bracing openings (1) and mount on backrest frame.

Fig 5: Identifying Backrest Cover Bracing And Airbag Module

Courtesy of BMW OF NORTH AMERICA, INC.