67 62... Notes on initializing power window unit in front door (coupe)

Initialization  is performed on the power window switch of the relevant door.

Requirements for correct initialization: 

• Terminal "R" activated
• Convertible top, doors and windows closed
• Sufficient battery voltage; connect charger if necessary

Initialization  comprises:

• Erasure of initialization
• Reinitialization

An initialization  must be performed:

• In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible
• After the power window drive has been replaced
• After work is carried out on the power window mechanism
• If necessary, after a power supply interruption, e.g. disconnection of the battery or disconnection of the power supply to the door
• After the door window glass has been removed and installed or replaced
• After adjustment work on the door window glass
• After adjustment work on the convertible top
• After replacement of seals

Erasure of initialization: 

• Open door window glass fully
• Actuate power window switch in "Open" position (second switch position) and hold down for between 15 and 20 seconds

This erases initialization of the power window, anti-trapping protection and toll function are inactive.

Check whether one-touch control (toll) function is inactive, otherwise repeat procedure.

Reinitialization: 

• Close door window completely
• Once the upper end position has been reached, hold power window switch in "Close" position (second switch stage) for approx. 2 seconds longer

This completes initialization.