22 11 110 Replacing left engine support arm (N51/N52/N52K/N53)
Necessary preliminary tasks:
- Remove underbody protection at front and rear
- Secure engine in Installation Position
- Remove Intake Filter Housing
- Remove Reinforcement Strut (E90/91/92 only)
- Remove V-strut (E93 only)
Release grounding strap from engine support arm.
Release screw (1).
Release corrugated tube (2) from retainer.
Release screws (3).
Remove engine support arm.
Installation:
Aluminium screws/bolts must be replaced.
For tightening torque refer to 22 11 3AZ in 22 11 ENGINE SUSPENSION .