22 11 001 Replacing right engine mount (N51/N52/N52K/N53)

Necessary preliminary tasks: 

• Secure engine in Installation Position .
• Remove underbody protection.
• Remove right V-strut (E93 only).

Release screws (1) and remove engine mount.

For tightening torque refer to 22 11 1AZ in 22 11 ENGINE SUSPENSION .

Installation: 

Rubber section (1) of engine mount must point to middle of vehicle.

Engine mount designations:

Right engine mount

• Even component number

Left engine mount

• Odd component number
  Fig 2: Identifying Rubber Section Of Engine Mount

  Courtesy of BMW OF NORTH AMERICA, INC.