LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2007 >> Z4 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Self Diagnosis - Diagnostic Trouble Codes - DTC P0010 - DTC P1198 (N51, N52) >> BMW MSV80 >> DTC P1006, BMW Hex Code 0x2A31, BMW Code 10801: VVT-Guiding Sensor Parity Error (Bank 1) (SIG) >> Repair procedures (plant/service)

Repair procedures (plant/service)

If fault codes (#10801) and (#10802) are simultaneously stored in the fault memory, proceed to check the following:

  1. Dual fault is stored when VVT sensor is not connected to the DME. Is VVT sensor connected to the wiring harness? If not: Plug in and check wiring harness between DME and VVT sensor. Determine whether the VVT sensor wire shield is grounded at the DME (PIN 7-10) and sensor (PIN 4).

Replace VVT sensor. If only fault code (#10801) is entered:

  1. Check signal wire (VVT sensor PIN 1, PIN 3) between VVT sensor and DME for breakage or short circuits and corroded plugs.
  2. Determine whether a
scientia non olet · About LEMON Manuals