11 31 Camshaft (N52)
CAMSHAFT TIGHTENING SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Upper and lower bearing strip of camshaft (steel screw) | N52 | M7x70 | Insert screws dry | |
| Jointing torque | 8 Nm | |||
| Torque angle | 60 ° | |||
| 2AZ Chain drive module to cylinder head | N52 | M6x35 | 8 Nm | |
| 3AZ Guide rail to crankcase | N52 | M8 | 20 Nm | |
| 4AZ Guide rail to cylinder head | N52 | M7 | 14 Nm | |
| 5AZ Chain tensioner to cylinder head | N52 | M22 x 1.5 | Replace sealing ring | 50 Nm |
| 6AZ Screw plug in cylinder head | N52 | M18x1.5 | 25 Nm | |
| 7AZ Bearing cap of inlet camshaft | N52 | M6x30.5 | 9 Nm |