11 13 Oil Pan (N52)
OIL PAN TIGHTENING SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Oil drain plug | N52 | M12 x 1.5 | 25 Nm | |
| 2AZ Oil pan on engine block Aluminium oil sump Aluminium screws/bolts are marked with blue paint. |
N52 | M8x26 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 90 ° | |||
| 3AZ Oil pan on engine block Aluminium oil sump Aluminium screws/bolts are marked with blue paint. |
N52 | M8x92 M8x112 |
Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 180 ° | |||
| 4AZ Oil pan on engine block Sheet metal oil sump Aluminium screws/bolts are marked with blue paint. |
N52 | M8x24 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 90 ° | |||
| 5AZ Oil deflector to crankcase lower section Aluminium screws/bolts are marked with blue paint. |
N52 | M6x20 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 90 ° |