51 14 110 Removing and installing/replacing rear model emblem
IMPORTANT:
The Instructions For Number/Letter Combination Cementing serve as the basis for these repair instructions and must be followed without fail.
Stick on top edge of adhesive tape (1) parallel to bottom edge of rear lid at distance "A".
Mark out distance "B" on top edge of adhesive tape.
Remove liner (protective strip for adhesive surface).
Position corner of number "4" at distance "C" and position letter "Z" with marked point on adhesive tape (1).
Dimensions:
A= 72 mm
B= 200 mm
C= 74 mm