51 43 201 Removing and installing/replacing panel for roof pillar at front (A-pillar), left or right
WARNING:
Follow safety instructions for working on cars with airbag systems (risk of injury), see 51 00 ... Safety instructions for working on cars with airbag systems
IMPORTANT:
Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).
Detach mucket (1) in area of panel (6).
Unclip protective cap (2) and remove.
Release screw (3).
Tightening torque: 51 43 2AZ, see 51 43 SIDE TRIM PANEL WITH ARMRESTS
Unclip panel (6) at fastening point (4).
Feed out panel (6) from instrument panel (5) and remove.
Installation:
If necessary, lever out clip (1) remaining in bore.
If necessary, replace faulty clip (1).
Make sure guides (3) of panel (2) are correctly seated in associated mountings.
Position panel (2) preinstalled with clip (1) on associated bore and clip into place.