51 12 156 Removing and installing/replacing rear bumper trim (M Technic aerodynamic kit)

Necessary preliminary tasks:

Remove trim on loading sill, see 51 12 080 Removing and installing/replacing trim on loading sill for rear bumper (from 09/2006)

Release screws (1) on bumper trim (2).

Fig 1: Screws And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and nut (2) on left and right.

Installation:

Make sure wheel arch trim (3) is in correct position.

Fig 2: Screws, Nut And Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Press wheel arch trim slightly to one side and release screw (1) on bumper trim (2) on left and right.

Fig 3: Screw And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bracket (2).

Fig 4: Screws And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Release nuts (2) and feed bracket out of stud.

Fig 5: Nut And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Do not detach bumper trim (1) at sides in outward direction.

Pull off bumper trim (1) for side panel in direction of arrow.

Fig 6: Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out bumper trim (1) in direction of arrow and remove with aid of a 2nd person.

NOTE: Version with Park Distance Control:
If necessary, pull off bumper trim (1) a little and disconnect plug connections of ultrasonic transducers (2).

Fig 7: Ultrasonic Transducers And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.