51 14 110 Removing and installing/replacing rear model designation

IMPORTANT: The "Instructions for number/letter combination cementing" serve as the basis for these repair instructions and must be followed without fail, see 51 14 ... Instructions for attaching number/letter designation combination

Stick on top edge of adhesive tape (1) to bottom edge of rear lid (2) at distance "A" and "B".

Mark measurement "C" from side edge (3) measured on top edge of adhesive tape.

Dimensions:

A= 50 mm

B= 55 mm

C= 77 mm

Fig 1: Adhesive Tape And Rear Lid

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Measurements "D" and "E" are for information purposes only, as they are determined by carrier film.

D= 15.6 mm

E = 170 mm