51 13 280 Removing and installing/replacing trim strip on roof frame at left or right
Special tools required:
Necessary preliminary tasks:
- If necessary, remove railing, see 51 13 305 Removing and installing/replacing left or right rail
Lever out trim strip (1) with special tool 00 9 321 starting at rear.
Unclip trim strip (1) up to front and if necessary pull out of seal (2) towards rear.
Installation:
Catches (1) of clips (2) must not be damaged.
If necessary, replace clips (2).
Installation:
Following parts of trim strip (3) must not be damaged or missing:
- Seals
- End piece, front/rear
Replacement:
Moisten seals (1) with water and slide into trim strip (3).
Fit end pieces (2) at front and rear.
Installation:
E83 only: Push trim strip (2) at front into seal (1).
Trim strip (2) must be flush with edge (3) at rear.
Clip trim strip (2) into place completely.