51 45 055 Removing and installing/replacing airbag cover on passenger side

Special tools required:

64 1 020 RELEASE HOOK

WARNING: Each time the passenger airbag is triggered, it is necessary to replace its airbag cover.
We cannot guarantee that the retaining straps of the airbag cover will not be damaged when the airbag is triggered.
If a damaged airbag cover is reused, we cannot guarantee that the retaining straps will work properly.

Necessary preliminary tasks:

Disconnect battery negative lead, see THE BATTERY - OVERVIEW - ALL MODELS .

Lever out airbag cover (1) with special tool 64 1 020.

Fig 1: Airbag Cover With Special Tool (64 1 020)

G04788797

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: If necessary, remove felt.

Fig 2: Felt

G04786574

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Remove adhesive residue and clean adhesive area with isopropanol.

Apply 5 mm dia. butylene tape (Terostat 2460) on left and right in groove.

A = 30 mm ± 2

B = 15 mm +5/-0

C = 40 mm ± 2

Fig 3: [Adhesive Area]

G04788799

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean adhesive area on airbag cover (3) with isopropanol.

Remove backing paper from butyl.

Lug (2) of airbag cover (3) must snap into groove (1) in instrument panel.

Fig 4: Lug Of Airbag Cover And Groove

G04786576

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove airbag cover (2).

Tightening torque: 72 12 10AZ, see 72 12 AIRBAG MODULES .

Fig 5: Screws And Airbag Cover

G04788801

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure turning lock of fitting (1) is correctly seated in bore hole.

Fig 6: Turning Lock Of Fitting In Bore Hole

G04786578

Courtesy of BMW OF NORTH AMERICA, INC.