51 12 156 Removing and installing rear bumper trim

Special tools required:

00 9 317

Necessary preliminary tasks:

Partially remove luggage compartment wheel arch trim on left . See 51 47 151 REMOVING AND INSTALLING/REPLACING LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIM .
Remove license plate.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Disconnect plug connection (1) and feed out wiring harness with cable grommet (2) in direction of arrow.

Fig 1: Disconnecting Plug Connection

G04760840

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on wheel arch trim (2).

Fig 2: Identifying Screws On Wheel Arch Trim

G04760841

Courtesy of BMW OF NORTH AMERICA, INC.

Release expander rivet (1) on bumper trim (2).

Fig 3: Identifying Expander Rivet On Bumper Trim

G04760842

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, release expander rivet (1) on guide (2).

Unclip guide (2) with special tool 00 9 317 from bumper trim (3).

Fig 4: Identifying Special Tool And Guide

G04760843

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bumper trim (2).

Unclip bumper trim (2) to side panel outwards.

Remove bumper trim (2) towards rear with aid of a 2nd person.

Fig 5: Removing Bumper Trim

G04760844

Courtesy of BMW OF NORTH AMERICA, INC.