51 11 ... Installing/replacing license plate (without base)

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm.

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Tightening torque 51 11 7AZ . See BODY EQUIPMENT - TIGHTENING TORQUES .

Fit protective caps.

Fig 1: Identifying Hole Template And Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure license plate (3) with license plate screw (4).

Tightening torque 51 11 8AZ . See BODY EQUIPMENT - TIGHTENING TORQUES .

Fig 2: Identifying License Plate And Screws And Rivet Nut

Courtesy of BMW OF NORTH AMERICA, INC.