72 12 000 Removing and installing/replacing airbag module on passenger side
WARNING:
Read and comply with safety regulations
for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause in jury.
Necessary preliminary tasks:
- Disconnect battery negative lead . See 61 00... SAFETY INSTRUCTIONS FOR HANDLING VEHICLE BATTERY .
- Remove complete right glovebox housing . See 51 16 367 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING (WITH ACTIVE KNEE PROTECTION) .
Release screws (1) and (3).
Remove retaining plate (4) in direction of arrow.
Installation:
Make sure centering element (2) is correctly seated on retaining plate (4).
Unfasten plug connection (2) and disconnect.
Unlock plug (3) and unclip in direction of arrow from airbag module (4).
IMPORTANT:
Secure airbag module (4) against falling out.
Release screws (1) and carefully remove airbag module (4).
Installation:
Replace microencapsulated screws.
Tightening torque 72 12 9AZ. See AIRBAG RESTRAINT SYSTEM - TIGHTENING TORQUES .