64 11 377 Removing and installing (replacing) control panel for heater - A/C system
Special tools required:
- 00 9 317
Necessary preliminary tasks:
- Remove radio receiver. See AUDIO, NAVIGATION AND ANTI-THEFT - REPAIR INSTRUCTIONS .
Lever out cover (1) with special tool 00 9 317 and remove.
Installation:
Make sure cover (1) is correctly seated.
Unlock plug connections (1) and disconnect.
Unfasten screws (2).
IMPORTANT:
To avoid scratches:
- Cover center console with a protective cover (1).
- Remove heater - A/C system control panel (2) carefully through opening (B).
Press out heater - A/C system control panel (2) in direction of arrow (A) and remove through opening (B).
Installation:
Check retaining clip (1) for deformation; replace if necessary.
Replacement:
Carry out coding/programming.
Observe following IDC specifications:
- Programming
- Coding
- Car & Key Memory
- CD "CIP"