51 47 000 Removing and installing/replacing front (inside) left or right entrance cover strip

Disengage retaining lugs (5) of entrance cover strip (2) from both adjoining panels.

Lever out entrance cover strip (2) at front retaining points (3).

Pull back entrance cover strip (2) and feed out of rear retaining points (1).

Installation: 

Position entrance cover strip (2) preinstalled with clips (4) on associated bores and clip in to place.

Installation: 

Clip mountings of entrance cover strip (2) must not be damaged.

Retaining lugs (3) of entrance cover strip (2) must not be damaged.

If necessary, lever out remaining clips (1) in floor panel.

If necessary, replace faulty clips (1).

Slide clips (1) into clip mountings of entrance cover strip (2).