51 45 185 Removing and installing/replacing panel for pedals
Release screws (1).
Release expansion rivet (3).
Pull back panel for pedals (2) in direction of arrow.
Disconnect plug connection for footwell, disconnect gong and remove panel for pedals (2).
Replacement:
Remove footwell light. (See 63 31 020 REMOVING AND INSTALLING/REPLACING FOOTWELL LIGHT )
If necessary, remove gong. (See 65 81 050 REMOVING AND INSTALLING/REPLACING GONG )
Installation:
Make sure guides (4) of panel for pedals (2) are correctly seated in associated mountings.
Make sure panel for pedals (2) is correctly seated on footwell vent above.