51 14 010 Removing and installing/replacing rear BMW badge

Special tools required:

IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail. (See 51 00 ... NOTES ON BONDING/ATTACHING COMPONENTS WITH DOUBLE-SIDED ADHESIVE TAPE )

Heat BMW badge (1) with hot air blower and lever out with special tool 00 9 322. (See BODY EQUIPMENT - SPECIAL TOOLS article)

Fig 1: Identifying Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pull liner* off adhesive tape (1).

Position badge over guides (2 and 3) and press down firmly.

* Liner is the protective film on a new badge.

Fig 2: Identifying Adhesive Tape & Guides

Courtesy of BMW OF NORTH AMERICA, INC.