63 21 170 Removing and installing/replacing left or right rear light

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).

Turn fastener (1) in direction of arrow and remove trim (2).

Fig 1: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

NOTE: Secure rear light (3) against falling out.

Release nuts (2) and remove rear light (3) towards outside.

Tightening torque 2.5 N.m

Fig 2: Identifying Plug Connection, Nuts And Rear Light

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure sealing frame for rear light (2) is correctly seated, replace Sealing Frame For Rear Light (2) if necessary.

Make sure guides (1) of rear light (3) are correctly seated in associated mountings.

Make sure (outer) gap of rear light (3) is uniform all round.

Fig 3: Identifying Rear Light Outer Gap, Sealing Frame And Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove all socket housings for rear light.