51 17 Flaps
FLAPS - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Hinge to drip moulding | E64 | Oval-head screw and washer assembly | 21 Nm | |
| 2AZ Hinge to drip moulding | E64 | Hexagon nut and washer assembly, microencapsulated | 21 Nm | |
| 3AZ Hinge to flap | E64 | Screw and washer assembly | 8.8 Nm | |
| 4AZ Hinge to flap | E64 | Multipurpose screw (ISA), self-locking | 8 Nm | |
| 5AZ Locking bar to convertible top | E64 | 8.8 Nm | ||
| 6AZ Kinematics box to body | E64 | 8 Nm | ||
| 7AZ Bracket, drive cylinder | E64 | 8 Nm | ||
| 8AZ Buffer stop, convertible top compartment lid | E64 | 8 Nm | ||
| 9AZ Trim, convertible top compartment lid | E64 | Hexagon nut and washer assembly | 4.6 Nm | |
| 10AZ Trim, convertible top compartment lid | E64 | Hexagon nut | 4.6 Nm | |
| 11AZ Cover housing to side panel | E85 / E86 | 3 Nm |