51 16 248 Removing and installing/replacing lock on rear storage box

Necessary preliminary tasks: 

• Remove panel for storage box upper section at rear  (See 51 16 236 REMOVING AND INSTALLING/REPLACING PANEL FOR STORAGE BOX UPPER SECTION AT REAR )

Release expansion rivets (1).

Pull up cover (2) slightly and unclip in upward direction.

Installation: 

Following parts of cover (3) must not be damaged or missing:

1. Catches
2. Mounts for expansion rivet

Release spring washer (1) and pull out pin with spring washer (2).

Release screws (1) on lock (2).

Feed out lock (2).

Installation: 

If necessary, press lock (2) to right (3) and tighten screws (1).

Make sure lock (2) is correctly seated on servomotor.