51 14 003 Replacing BMW badge on side direction indicator
Special tools required:
- 00 9 323
IMPORTANT:
The Instructions
on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail. (See 51 00 ... NOTES ON BONDING/ATTACHING COMPONENTS WITH DOUBLE-SIDED ADHESIVE TAPE )
Heat badge (1) with hot air blower and detach with special tool 00 9 323. (See BODY EQUIPMENT - SPECIAL TOOLS article)
NOTE:
To assign the badge correctly to the left or right side direction indicator, it will be necessary first to fit the badge on the mounted side direction indicator.
Installation:
Position badge (2) over guides (3) and stick on.
Remove side direction indicator. (See 63 13 200 REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT AUXILIARY TURN SIGNAL LAMP )
Press down badge (2) firmly on side direction indicator (1).