51 12 050 Removing and installing/replacing carrier for rear bumper trim

Necessary preliminary tasks: 

• Remove rear bumper trim  (See 51 12 156 REMOVING AND INSTALLING REAR BUMPER TRIM VERSION WITH PDC: )
• Remove trim on tail panel  (See 51 46 050 REMOVING AND INSTALLING/REPLACING TOP TRIM ON REAR APRON )

If necessary, unclip aerial (1) in area (2).

Fig 1: Identifying Aerial

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) on left/right and remove carrier straight towards rear.

Tightening torque 51 12 3AZ.  (See BODY EQUIPMENT - TIGHTENING TORQUES article)

Fig 2: Identifying Nuts On Left/Right Of Carrier

Courtesy of BMW OF NORTH AMERICA, INC.