51 43 255 Removing And Installing / Replacing Trim For Rear Left Or Right Roof Pillar (Front)

WARNING: Version with head airbag:
Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Necessary preliminary tasks:

Remove trim for rear roof pillar (rear) . See 51 43 251 REMOVING AND INSTALLING / REPLACING TRIM FOR REAR LEFT OR RIGHT ROOF PILLAR (REAR) .

IMPORTANT: Lever out expander rivet heads (1) only over groove (3) on lower section (2). If necessary, turn lower section (2) with groove (3) towards front.

Release clip (4) and remove trim (5) towards inside/top.

Fig 1: Identifying Slacken Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommet (1).

Fig 2: Identifying Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clip (1).

Bores (2) and insulating mat (4) of trim (3) must not be damaged.

Fig 3: Identifying Insulating Mat Of Trim And Bores

Courtesy of BMW OF NORTH AMERICA, INC.