41 34 041 Tail Panel Complete Replacement

Spot-weld bonding is used for the first time on the E65. A specific procedure must be followed here.

Following new body parts are required:

• Rear trim, complete
• End panel, rear lights base, left and right
  Fig 1: Identifying Rear Trim And End Panel

  Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Open brazed joints in areas (2).

Fig 2: Identifying Brazed Joints Areas And Weld Joints Area

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in areas (1) on inside of luggage compartment on left and right.

Remove plate (2) and tail panel.

Fig 3: Identifying Plate And Tail Panel

Courtesy of BMW OF NORTH AMERICA, INC.