41 34 038 Outer Tail Panel Section Replacement

Spot-weld bonding is used for the first time on the E65. A specific procedure must be followed here.

Following new body parts are required:

• Rear trim outer skin
  Fig 1: Identifying Rear Trim Panel

  Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Release bond in areas (2) with hot air blower.

Installation: 

Apply adhesive in areas (2).

Fig 2: Identifying Bond In Areas With Hot Air Blower

Courtesy of BMW OF NORTH AMERICA, INC.