51 24 100 Removing And Installing/Replacing Rear Lid Lock (Upper Section)

Necessary preliminary tasks: 

• Remove panel for rear lid  . See 51 49 005 REMOVING AND INSTALLING/REPLACING TRIM FOR LOWER REAR LID .

Unlock catch (1) and detach Bowden cables (2 and 3) from rear lid lock upper section (5).

Version with manual unlocking: 

Installation: 

Bowden cable (2) must be correctly positioned in guide (4).

Release screws (1).

Unscrew rear lid lock upper section (2), disconnect plug connection and remove.

Tightening torque 51 24 5AZ.  See BODY EQUIPMENT - TIGHTENING TORQUES -- ALPINA .

Installation: 

Perform function check with rear lid open.

• Adjust rear lid lock  . See 51 24 004 ADJUSTING REAR LID LOCK (LOWER SECTION OF REAR LID LOCK) .

Replacement: 

Release screws (1).

Detach servodrive (2) from rear lid lock upper section (3) in direction of arrow.