66 54 010 Removing And Installing Complete Night Vision Camera
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)
. See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary tasks:
- Remove front bumper trim . See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .
- Remove front underbody protection . See 51 47 490 REMOVING AND INSTALLING / REPLACING FRONT UNDERBODY PROTECTION .
- Remove air duct for brake ventilation on left sides
- Partially remove cooling air duct
- Remove air duct (brake)
Unclip tube (1) from guide.
Disconnect associated plug connection.
Unscrew nuts (2).
Tightening torque 66 54 1AZ .
Release screws (1).
Tightening torque 66 54 1AZ .
Disconnect hose connection (2) and remove holder with night vision camera (3).
After installation:
- Fill up with washer fluid
Replacement only:
- Replace night vision camera . See 66 54 511 REPLACING NIGHT VISION CAMERA .
- Carry out coding/programming . See VEHICLE PROGRAMMING AND CODING .
- Adjust night vision camera . See 66 54 001 ADJUSTING NIGHT VISION CAMERA .