72 12 010 Removing and installing/replacing airbag module on left or right front door
WARNING:
Read and comply with safety regulations
for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
- Disconnect battery negative lead
Follow instructions for disconnecting and connecting battery!
- Remove front door trim
Release nuts (1) and remove holder (2).
Installation:
For tightening torque refer to 72 12 01AZ in 72 12 AIRBAG MODULES .
Coat nut and thread with paint (any color and type can be chosen).
Fold back tabs (1) of plastic housing and remove airbag module (2) from airbag mounting.
IMPORTANT:
There must be no foreign bodies (e.g. screws, nuts, etc.) in the airbag mounting (1).
Installation:
Slots (2) of holder (1) must be above threaded pins (3).
Point angled part of holder (1) to door trim panel.